Rover 450
13-12-2008, 13:02
hi hope someone can help with this
ive got a problem with the imobiliser on my 45 it started on weds my clifford alarm stopped locking the car so i changed the fuse as it had popped, then when i did this my rover imobiliser activated itself again and when i went to start the car it would bleep, after spending hours finding the rover fob i de-activated the rover imobiliser but the car still wont start it just turns over. I think the problem is due to the fuel pump because i cant hear it when i turn the ignition to number II, although it was working fine before ?
Need a little more info!
Petrol or diesel?
hi hope someone can help with this
ive got a problem with the imobiliser on my 45 it started on weds my clifford alarm stopped locking the car so i changed the fuse as it had popped, then when i did this my rover imobiliser activated itself again and when i went to start the car it would bleep, after spending hours finding the rover fob i de-activated the rover imobiliser but the car still wont start it just turns over. I think the problem is due to the fuel pump because i cant hear it when i turn the ignition to number II, although it was working fine before ?
Do you know if your Clifford is wired to the fuel pump ?? i Know Thatchams are. Is the Clifford working ok now ?? Check the fuse for the fuel pump too, just in case.
Mark.
Rover 450
13-12-2008, 13:24
its a rover 45 petrol. the clifford was wired in to the loom by gap security but since then i have taken the engine and loom and put it in a different car and this is when the problems started, every time i would use the rover fob it would pop the fuse so i just didnt bother with the rover alarm i just had used the clfford which had been ok till weds. i have checked the fuel pump fuse and its ok
This is going to be a complex problem, as the engine and loom have been swapped to another car.
All you can do is check the wiring running off that fuse for shorts to earth.
Rover 450
13-12-2008, 16:13
i just stripped down the under the steering wheel and looked for a bare wire but couldnt find any i un hooked the clifford and it made no difference, i did realise though that it pops the fuses when the doors are unlocked but ok when locked, i starting to think that the fuel pump not working may have nothing to do with the alarm but im not sure