MG-Rover.org Forums - Blog Entries
 
 
 
Go Back   MG-Rover.org Forums > Blogs

Old

Many a true word. Lol.

Posted 08-10-2014 at 10:26 by COLVERT
I have a little Satnav, I've had it all my life
It's better than the normal ones, my Satnav is my wife.

It gives me full instructions, especially how to go.
"It's sixty miles an hour", it says, "You're riding far too slow !

It tells me when to stop and start, and when to use the brake
And tells me that it's never ever, safe to overtake.

It tells me when a light is red, and when it goes to green
It seems to know...
Registered User
Posted in Uncategorized
Views 287 Comments 0 COLVERT is offline Edit Tags
Old

MG ZS - Front and rear brake pads and discs

Posted 13-09-2014 at 20:58 by gnu
A reliable year for the ZS - so nothing to post on here for a while about it. But time for a service and the dreaded MOT. as well as the normal service, the brake discs were in a poor state, and attracted an advisory on last year's MOT so I decided to change them all, and change the pads and paint the calipers whilst I was at it. As there are plenty of good guides on here already, so I'll just post a few pics of what I did...

FRONT

The old discs through the wheels:
...
gnu's Avatar
gnu
No limits
Posted in MG
Views 376 Comments 2 gnu is offline Edit Tags
Old

Day 1 of owning a MG ZR 105

Posted 05-09-2014 at 22:56 by SiSwipe
Its in good shape will upload some photos tomorrow. Unable to open /unlock the drivers door. Will be going to the Scrapyard tomorrow to see how much they want for a new mechanism..

Engine bay is clean and no gunk in the oil, level is good too.

Tires are all good and MOT is good till August!
lets see what will happen tomorrow..
Registered User
Posted in Uncategorized
Views 251 Comments 0 SiSwipe is offline Edit Tags
Old

metro t16 loom

Posted 31-08-2014 at 20:21 by antere
hi got rover 620ti engine in my metro does anyone know how to do wiring
Registered User
Posted in Uncategorized
Views 250 Comments 0 antere is offline Edit Tags
Old

Rover 214 CV / Ball Joint Gaiter replacement

Posted 23-08-2014 at 16:44 by gnu
I've not posted here for a while, as the zs and R214 haven't needed anything doing to them bar normal services; giving me more time for my current project! However, the R214 failed it's MOT on a split CV joint gaiter a week ago, so I needed to get out the toolbox again.

It had split really recently, probably after I'd done the pre MOT check with a service about a month ago, so the grease was still ok on the joint and it was not unduly worn. Thus I opted to just replace the boot with...
gnu's Avatar
gnu
No limits
Posted in Uncategorized
Views 981 Comments 0 gnu is offline Edit Tags

All times are GMT. The time now is 21:55.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
ShowCase, Vendor Tools vBulletin Plugins by Drive Thru Online, Inc.