MG-Rover.org Forums banner
M

Reaction score
18

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews About

  • · Registered
    Joined
    ·
    231 Posts
    Could not send a private message it said you don't accept them.

    Fitting was fairly straight forward although the instructions in the box are a bit lightweight.

    Only fits one way the only choices I had were, whether to change the cold feed duct from the aluminum supplied one to to a high temp silicone one about £20 for 1.5m.

    I did the latter in the end and ran the cold air feed to the front passenger blanked off plate not sure if its same on pre face lift ?

    Terry at TS autos helped make that bit of the mod and checked the fitting was fine.

    You can route it to the under panel and cable tie it so air feed from down rather than forward facing, I found this to give more of the whoosh sound but nothing loud or shameful.... The Front feed I now have is quieter than a down feed approach.

    I think as this is an enclosed unit you don't get the same as the open cone type designs.

    Let me know if you are over this way (Brum/Walsall) and you can come have a look any time.
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top