MG-Rover.org Forums - View Profile: E_T_V

E_T_V E_T_V is offline

Registered User

  Visitor Messages

Showing Visitor Messages 1 to 10 of 85
  1. Super-Sid
    29-01-2017 15:00 - permalink
    Super-Sid
    hi E_T_V
    I posted a thread about my zr wont turn over today would be so grateful for your input as your answers and views to problems seem to be the correct one plus I'm pulling my hair out over my zr not turning over.
    thanks
  2. yargnitram
    25-03-2016 03:46 - permalink
    yargnitram
    hi is there any chance of giving me details of how to rewire bypassing the immobiliser on my rover 220 GTI with a 550 ecu, i am in new zealand thanks
    gary
  3. finyuk2005
    16-03-2015 16:38 - permalink
    finyuk2005
    the t4 is mechanical, but as i am using the rover gearbox i was planning to just extend or heat and bent the rover linkage to suit, i have a td zs that i am going to use the gearbox from as thats a hydraulic clutch and so is the van so thats nice and easy.
    interesting that the tf setup is cables, definitely something to bear in mind
  4. finyuk2005
    15-03-2015 23:44 - permalink
    finyuk2005
    ah right thats encouraging then, the wiring was what i was most worried about, yeh gearbox is going in too, driveshafts will be cut and rewelded to give an mg inside and vw outside splines, linkage like you say could be a challenge, i was thinking though that as long as you extend or chop down the two parts of the linkage by the same amount it should work right?
  5. finyuk2005
    10-03-2015 21:29 - permalink
    finyuk2005
    hey dude, been reading your blog on your camper again as i am planning an engine swap in my (future! its getting there!) camper, a vw t4. yep. i am putting an L series in it!
    i was just wondering if you had any words of wisdom for tackling the wiring mainly, i know it will be slightly different as i am using a later r25 engine so there may be slightly more to it than the r600 wiring, but any advice would be gratefully recieved!!
    thanks
    Finlay
  6. t16tony
    29-01-2015 19:14 - permalink
    t16tony
    hi there

    sorry to hi-jack, i see you replied to a messaged regarding a pg1 gearbox suitable for a 220 coupe. Did you have something available?

    kind regards
  7. daryl1104
    23-05-2014 16:48 - permalink
    daryl1104
    Hi my zs diesel has a stutter on tick-over not actually misfiring.I have recently fitted sdi injectors out of a car that I ran before so I know they are ok ish,the car is running with egr blanked mafam set for sdi and economy mode,the cat has been gutted and a sheilded cone air filter,if I apply slight load on engine like as on hill start holding on clutch but still on idle the hesitation is not evident,when it does hesitate the rpm does not fluctuate,the car performs perfect other wise othe than a pin hole on the turbo rducer hose which is on order,what is your thoughts on this one,many thanks Allan
  8. Speedqueen
    15-02-2014 21:48 - permalink
    Speedqueen
    Hello iv been told your the person that can help me
    Please I have a t series and iv got some m series rods and o series pistons how much mil has to come off the bottom block to get compression right your help is much appreciated thanks
  9. Pandy
    14-12-2013 00:38 - permalink
    Pandy
    Emptied mate, thanks.
  10. lydecker_777
    22-06-2013 00:17 - permalink
    lydecker_777
    legend......... !

  About Me

  • About E_T_V
    Where did you hear of this site?
    Other
    What make of car do you drive?
    Maestros, 200, 600, ZTT
    Any modifications to your car?
    Too many to list here.
    Your Country
    United Kingdom
    Location
    Under a car near scunthorpe
    Interests
    Cider and women
    Occupation
    Making tracks

  Statistics

Total Posts
Visitor Messages
Blog
General Information
  • Join Date: 26-05-2004
  • Referrals: 0

  Friends

Showing Friends 11 to 14 of 14
  • PaulMGZR105
    • PaulMGZR105 is offline
  • paulr600sdi
    • paulr600sdi is offline
  • Tko15
    • Tko15 is offline
  • ziobobby
    • ziobobby is offline
    • Send a message via MSN to ziobobby

  Contact Info

Instant Messaging
Send an Instant Message to E_T_V Using...
Home Page
http://www.roverdiesel.co.uk
This Page
http://forums.mg-rover.org/members/e_t_v-6081/

  Mentions

No results to display...

  Quotes

05-02-2017
15:01 - E_T_V quoted Ed3 in post Which priorities for L series 2.0td ?
It is doing about 42 to ...
14:55 - E_T_V quoted MGFAST&FURIOS in post timing belt change
Hi guys, can anyone tell me how I need...
02-02-2017
22:44 - E_T_V quoted ROVER-25X in post K Series Turbo vs T16
Yeah Catterall2 had a Rover 40...
21:43 - E_T_V quoted Talkingcars in post K Series Turbo vs T16
Early T16 with dizzy were 180bhp...
31-01-2017
13:01 - E_T_V quoted david.c in post Head Gasket
Don't buy the gasket until y...
30-01-2017
13:32 - E_T_V quoted rocket_rover in post Turbo shaft play
Yes that's the info was using whe...
11:49 - E_T_V quoted galley.r25 in post Type B torsen box gear ratios
Hello all, Does anyone know ...
24-01-2017
20:05 - thefarmer quoted E_T_V in post Strange cooling system issue
Thanks for the replies. :)...
22-01-2017
20:01 - Nomad76 quoted E_T_V in post ROVER 25, 2.0 IDT ... MAP or EGR problem
Unplugging the MAF sensor ...
19:16 - dert quoted E_T_V in post Cloning!!!
Could also be he has been ...
19-01-2017
21:08 - E_T_V quoted Bathrat in post Can I convert an sdi injector
So is it just the nozzles th...
21:06 - E_T_V quoted Masterbateson in post Can I convert an sdi injector
Ere Whats all this about swapping ...
18-01-2017
10:00 - E_T_V quoted Masterbateson in post No thread for towbar wiring on a ZTT-T?
Yeah Have read bits here and there...
16-01-2017
21:15 - gruber8 quoted E_T_V in post Deleted Posts
13:40 - Bunny_Brain quoted E_T_V in post Injector pump tentioner
I think the belt change in...
13:13 - E_T_V quoted ROVER-25X in post Lets show off your R8's!
ROVER & SPORTY Words that g...
13:11 - E_T_V quoted gruber8 in post Deleted Posts
13:02 - E_T_V quoted gruber8 in post Deleted Posts
14-01-2017
17:27 - Bunny_Brain quoted E_T_V in post Injector pump tentioner
Belt is thinner on the lat...
10-01-2017
22:41 - Nomad76 quoted E_T_V in post ROVER 25, 2.0 IDT ... MAP or EGR problem
Depends on what car you ha...
 
For the best viewing experience please update your browser to Google Chrome