I have seen the kits to upgrade to mems 3 from K-maps and the work involved , if you went to an Emerald is it the same amount of work ie engine loom ect.
If you get a Emerald its a easy swap just get the loom they do to join the K6 to your original wiring loom then you can get a proper map done for your car all tho you wont get much from a standard engine
In terms of raw cost, up grading to MEMS 3 and a Kmaps will be cheaper, especially if you do the MEMS conversion
but
Emerald is more adaptable.
Either way you will need to spend big of physical upgrades on the engine to make full benefit.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
MG-Rover.org Forums
5.9M posts
138.8K members
Since 2001
A forum community dedicated to MG & Rover owners and enthusiasts. Come join the discussion about performance, troubleshooting, upgrades, maintenance, and more!