WHATS THE TRICK TO GET THESE TO STAY IN WHEN YOU PUT IN THE NEW PADS
OR DO YOU PUT THEM IN ONCE THE NEW PADS ARE IN
A bit baffled here they keep falling out..
I am assuming you mean the the stainless steel sliders that the rear pads slide on, again I just used a coating of copper slip to hold them into place whilst fitting the pads.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
MG-Rover.org Forums
5.9M posts
138.9K members
Since 2001
A forum community dedicated to MG & Rover owners and enthusiasts. Come join the discussion about performance, troubleshooting, upgrades, maintenance, and more!