Join Date: Apr 2007
Location: S.E London
Car: Rover 75
SYNERGY 2, Switch Settings
I have lost the instructions on the setting up for the SYNERGY 2, I have the information on the rotary switch, but am not sure if the MAF switch should be on or off if you have Ron's PIERBURGH senor?
Also does the air temp sensor need to be drilled into the MAF housing or into the air filter box.
Join Date: Jan 2004
Car: Other Manufacturer
Both switches on and use setting 4 or higher with a Pierburgh maf.
Try the temp sensor in a warm place eg on top of engine as some find this improves mpg.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Display Modes||Rate This Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Synergy settings, setting 10 ?||teadrinker||MG ZT / Rover 75 (Sponsored by Rimmer Bros)||5||19-04-2008 21:21|
|Synergy TU3b with remote dash switch||X Power Grey||MG ZT / Rover 75 (Sponsored by Rimmer Bros)||1||25-02-2008 07:53|
|Cruise switch exploded - and ideas for a switch for the Synergy module||Rob Bell||MG ZT / Rover 75 (Sponsored by Rimmer Bros)||16||19-10-2006 19:38|