Fitting new Crankshaft Position Sensor - MG-Rover.org Forums

Enak · 09-12-2004, 16:35

I am gonna replace the Crankshaft Position Sensor... Is there anything I should be aware of or is it as simple as the haynes manual says?

Dan Coupe · 09-12-2004, 16:50

Its a bit of a pain to find and reach! Also, it can be difficult to find the hole to relocate the new part. Think the (single) bolt holding it is 8mm - but I could be wrong as its a couple of years since I fitted one.

09-12-2004, 16:35	#1
Enak Registered User Join Date: Jan 2004 Location: Hertfordshire, UK Car: MG ZS Posts: 1,195	Fitting new Crankshaft Position Sensor I am gonna replace the Crankshaft Position Sensor... Is there anything I should be aware of or is it as simple as the haynes manual says?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Crankshaft position sensor	Chris T	MGF and MGTF (Sponsored by MGF Mania)	8	07-11-2008 21:26
Starting Problems - Crankshaft Position Sensor???	andywhitehurst	MG ZR / Rover 25, 200 & Streetwise	2	14-08-2007 16:34
Crankshaft Position Sensor Replacement	andywhitehurst	MG ZR / Rover 25, 200 & Streetwise	2	23-04-2007 18:53
420SDi Crankshaft Position Sensor Problem??	Spiiney	MG ZS / Rover 45 & 400	7	24-04-2006 13:57

09-12-2004, 16:50	#2
Dan Coupe Supporter Join Date: Dec 2002 Location: Cheshire Car: MG F (Mk II) & Rover Streetwise Posts: 3,003	Its a bit of a pain to find and reach! Also, it can be difficult to find the hole to relocate the new part. Think the (single) bolt holding it is 8mm - but I could be wrong as its a couple of years since I fitted one.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)