MG-Rover.org Forums banner

Search results

1-20 of 65 Results
Advanced Search
  1. Need help

    MG ZS / Rover 45 & 400
    When did the problem start? make sure the connection is fine between the airbag harness, if you are not familiar with the process take it to a specialist(be extra careful with that, as you could be more expert than some of them),now, If you are, take both battery poles with the light switch on...
  2. MG ZR / Rover 25 Earth Points Locations Guide

    MG ZR / Rover 25, 200 & Streetwise
    Awesome!!!
  3. My summer fix, could not take pictures from everything.

    MG ZS / Rover 45 & 400
    Good morning, I just wanted to upload these
  4. MG ZR / Rover 25 Earth Points Locations Guide

    MG ZR / Rover 25, 200 & Streetwise
    Blur pictures!!!!!
  5. How far out can valve timing be?

    MG ZS / Rover 45 & 400
    Hello! I just wanted to reply to this! In Corfu I went to High!! quality service store because I had a strange noise in my car! I told him not to rev it to high because I have an issue with the engine, and immediately he hi rev the car! I wanted to slap him, but I just didn't go there again, I...
  6. Rimmer Brothers Discount for show!

    MG ZS / Rover 45 & 400
    :sleigh: :gangbang: -15% for delivery to 10-12th November Lancaster Insurance, Classic motor Show, The Nec Birmingham 2017 EX1717D when ordering by Phone/Fax/E-mail and EX1717W for the Promotional Code Box on the checkout screen of the website Goodmorning!!!
  7. MG ZS Crackshaft Pully Help !!

    MG ZS / Rover 45 & 400
    The exhaust in must be by the inlet side not exhaust! Check this one normally it is OK all the way around you got it a little bit wrong here, normally the 2 dots must be in the opposite side from the straight line! Can you upload some pictures! Blind guidance is dangerous! Στάλθηκε από το m3...
  8. drift/torque steer under acceleration and deceleration

    MG ZS / Rover 45 & 400
    It is this one http://www.rimmerbros.co.uk/Item--i-RBX000132 left or right, to check lift the wheel and push with force with your foot, both sides!
  9. Head Gasket Bolts question

    MG ZS / Rover 45 & 400
    ok I did not meant to underestimate you! I don't claim that I know better, we have a conversation here, nothing personal, when you give advice that you are sure it is ok to let some space for a better opinion you might get! No one has the complete knowledge, otherwise this forum would not be...
  10. Head Gasket Bolts question

    MG ZS / Rover 45 & 400
    I think high tension bolts would add to cars protection even if the problem was not so big! So let the 200 bhp because even with the normal compression you could have a head gasket problem easily if you go to service and they tell you not to change the thermostat(and find out it is rusty...
  11. Head Gasket Bolts question

    MG ZS / Rover 45 & 400
    Can I change them one by one without to change the gasket? Just in case I want the more hard ones! No problem with the gasket after one year that I fixed it but I want to know! Thank you!!!
  12. Rover 400 95 on single stage to dual stage airbag!!!

    MG ZS / Rover 45 & 400
    I did not find anything through searching so I took the decision to post in order to request a guide!!! Thank you everybody for your time!!!!!
  13. Could that be a front bush problem??? Any bush??

    MG ZS / Rover 45 & 400
    Thank you very much for your reply!!! I will check those!
  14. Could that be a front bush problem??? Any bush??

    MG ZS / Rover 45 & 400
    When going forward must turn a little bit left to go straight but, when I go back I going straight without to turn!!! I can not describe it better!
  15. Temp gauge stable!

    MG ZS / Rover 45 & 400
    Thank you for your reply, all of you! It is not OBD 2 though!!!
  16. Temp gauge stable!

    MG ZS / Rover 45 & 400
    I did read somewhere that Rover did a fix on the temperature gauge and it stays little bit lower than the middle even if the the real temperature is higher! Is that true? If yes is there any way to fix it and go up and down normally? Thank you for your time!!!
  17. Rover 200vi turbo

    Show us your Projects!
    You got that!!! Massive work!!! I wish I could that to mine, but as long as it is running fine I have no problem! I wish you have a fantastic ride!!! That's a very good job even though you are not good with spark plug gaping! :A+: (apo forum xexe)
  18. more than 1 volt output oxygen sensor???????????

    MG ZS / Rover 45 & 400
    Thank you for your replies!!! I will read the page!!!
  19. more than 1 volt output oxygen sensor???????????

    MG ZS / Rover 45 & 400
    You are correct! I wait to work in the summer and buy the Bosch!!!
  20. more than 1 volt output oxygen sensor???????????

    MG ZS / Rover 45 & 400
    Thanks!!! Hello and thank you for your reply!!! The sensor is brand new but universal!!! With the previous one the car was like kangaro but with this one is stable! i put some resistance to the cable some ohms and now stays under 1 volt and it seems it is working in closed loop! the sensor...
1-20 of 65 Results
Top