MG-Rover.org Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi all
I have a 1990 1.1 K8 Carb which I got with a blown headgasket. The machinists took 1.5mm off the head (there was still a little pitting around No.1)
Anyway, put in an MLS headgasket and shim. The headgasket went again a few weeks later. Fantastic.
I know that this engine was absolutely BBQ'd and then left sitting so I'm going to put another engine in.
My question here is can I take an injected (single or multi point) 1.1 and replace the injection setup with the original carb gear?
Also does anyone errr...happen to have a cheap but good K8 1.1 under their workbench? Unfortunately my budget is very tight...
Cheers!
 
1 - 1 of 1 Posts
Top