MG-Rover.org Forums banner
1 - 1 of 1 Posts

·
Registered
Rover 75 V6 estate / wagon Connoisseur
Joined
·
4 Posts
Discussion Starter · #1 ·
I've noticed that the left hand rear corner of the driver's seat cushion is lifting up / jiggling a bit around corners, around 5 mm play

I've unbolted the seat to see if there were any loose nuts / screws etc etc but all seems fine / tight

It seems there is now a bit of a gap between the metal seat base and the upper leather seat cushion itself. This does not exist on any other seats / corners

Has anyone pulled a seat apart as I can't work out how the bottom seat cushion is connected the the metal frame (eg no bolts or nuts that I can see / feel)

There seems to be a metal flange (near the 10 in the pic) that could have been bent up a bit over the years causing the gap but it seems unlikely that would be the only thing holding the seat cushion to the frame

Pic of where the gap is

1621739030456.png

.
 
1 - 1 of 1 Posts
Top