MG-Rover.org Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter #1
hi guys

finished most of the work needed on my rover
just a few patches here and there and the rear shock replacements

can anyone help dumb down the swap?
i read the haynes manual and i understand very little, same as my dad
if pictures could be added as well

also im looking for a full set of coils
i think the car was lowered before i had it and the roads are quite hilly and low cars wont do most of the time also i dont know if its a cheap mod (quite probably as that often happens here) or a proper mod.

im sure theres good stock parts on rimmer bros but im wondering if theres better quality springs anywhere else
 

·
Registered
rover_25
Joined
·
276 Posts
to replace the rear shocks, undo the bottom shock bolt, push the rear seats down and remove the trim covering the shock covers, and undo the last 2 bolts, takes 15 mins a side
 
1 - 3 of 3 Posts
Top